5 axis breakout board for stepping motor controller

Categories

There are no subcategories.






Acceptance Mark



Share







Pin It
Other products by Lightobject
Item #: ECNC-5XBO-V5
Reg. Price: $39.50
Our Price: $19.50
Quantity:
 
93 units available

Description 

5 axis break-out board for CNC stepping motor. Supports Mach3 and KCam.


Features:
  • * Supports 5x stepping motor simultanously
  • * Built-in Relay control for spindle
  • * Supports limit sensor input

Specification:
  • * In/Out Interface port: Parallel
  • * On board Spindle Relay control
  • * Channel: 5 -> X, Y, Z,A,B
  • * Power: DC 5V
  • * Support: March2, KCam

Reviews

Average Rating:
(based on 4 reviews)

Showing 4 Reviews:

RatingReviewerReview
by William
on 10/17/2011
5 Axis CNC brake out board.
I have just received my board and no manual. I read that a manual is at the support site, Where is the support site that have this manual.
by Marco
on 4/1/2011
Manual
Manual is available at the Support site http://www.lightobject.info
by Karl
on 3/30/2011
No manuel
I just received the break-out board, it looks good but there's no diagram showing how to make the connections and the labeling on the board itself is not clear at all. I would like you to please post a wiring diagram or send it by email. Thanks! Karlk699@gmail.com
by Paulo Waisberg
on 11/13/2010
No manual
I just received the break-out board, it looks good but there's no diagram showing how to make the connections and the labeling on the board itself is not clear at all. I would like you to please post a wiring diagram or send it by email. Thanks!
Review and Rate this Item