LightObject 800W CO2 Laser Machine Chiller/Cooler (AC110V)

click on thumbnail to zoom

Other products by : Lightobject
 Item# :   WC-LO850W1V6
29 units available
  MSRP :   $695.00
  Price :   $495.00
 Quantity :  



LightObject water chiller for CO2 laser machine (AC110V 60Hz)   


High Efficiency and Quality Built water chiller


High efficiency and stability are the most important requirements for a water chiller. Without help from a microcontroller, it is  mission impossible. The LO-800W comes with a sophisticated microcontroller feedback system to get fast response. All setup tests can be performed through a large LCD screen control panel. It is easy to read and no tedious or complicated programming experience is needed.


The LO-800W is ideal for a machine with a single 80W~130W tube. It is a high performance water chiller with an excellence QC control. Low defective rate, quality made, and better price that you can find anywhere else in the market! It can also be used part-time for 150W peak power  tube.


  • Environmently friendly freon R410A
  • Microcontroller control with LED panel
  • Compact design with 0.3'C temperature accuracy
  • Compressor delay circuit, over-current protection
  • Over-heat temperature alert, water flow protection


  • Cooling Power: 850W
  • BTU: 3500Btu/h
  • Input power: AC 110V, 60Hz
  • Current: 3.5A
  • Compressor power: 0.5HP, 398Watt
  • Freon: R410A
  • Pump power: 30W
  • Lift (cut off) : 5m (16ft)
  • Rate: 10L/min, 158GPH
  • Inlet/Outlet size: 10mm
  • Ambient Temp.: ≤35'C (95'F)
  • Chilled Water Temp. 18~30'C
  • Water tank capacity: 8L/ 2.2Gallon
  • Weight: 25KG (50lb)
  • Dimension:550×280×430mm (21.6" x 11.0" x 17")

800W water chiller manual can be downlaoded from here.



Average Rating:
(based on 1 review)

Showing 1 Review:

by James
on 11/18/2016
LO800 Well worth the money.
Received package in only a few days. Has great simple instructions. Have used similar cooler so can not say if they are adequate for someone with no experience. Only issue is not being able to see the level line from the front. You have to leave your lines longer to be able to fill and check. Had to check my tube for the first week every time as it would put bubbles in the line at power on. But that has since stopped and I just take a glance to make sure the tube is clear.
Review and Rate this Item