Key Features of the 8A
- Three modes: Toggle, Momentary,Latched
- Encode/Decode to avoid interference
- Individual relay
- Can be programmed to handle two different modes
Specification
- Distance: 150M(450 feet)
- Power supply: 12V
- Encode/Decode: Yes(Learning Code)
- Control Type: Quad mode:( Momentary, Toggle, Latch, Momentary+Toggle)
- Relay: 10A/125VAC, 10A/14V DC
- Receiver Board Size: 8cm x 10cm x 3cm
- Remote Size: 5cm x 12.5cm x 2cm
Modes:
- Toggle: Press=On, Press again=Off
- Momentary: Press=On, Release=Off
- Latched: Press=On, Release=On (locked)
(2)
Average rating 7 out of 10
( based on 2
reviews )

Unit works ok
The instructions are hard to find and not sure they are right but they get you there, The antennas are too long and actually shorten the range a lot but the product overall is good.
8 bit RF controller
The hardware is good. I'm using it for wireless control of a scissor lift. However, there is no documentation shipped with the unit. The programming instructions provided via a forum are inaccurate. Vendor response is poor. If the documentation and trouble shooting assistance was better I would give it an excellent rating.