Power table for P530 laser machine

click on thumbnail to zoom
Other products by Lightobject
Item #: LSR-PWRTB530
Our Price: $315.00
Quantity:
 
42 units available

Description 

This is a power bed designed for the "PR530" small desktop CO2 laser machine. With this power bed,The traveling distance is 6.4cm (2.5"). By having this power bed would, it save you a tremendous time of doing height adjustment as laser focus point is very important for fine engraving. Losing focus means losing cutting power. The power bed is great for other project when lifting feature is needed.

The unit came as a kit. It should take less than 90 min to set it up. It's fun to build it!

No manual inclued but we will provide step by step photo to follow. DIY

Specification
- Table Size: 21 5/8" x 13 3/4" x 4 1/8" or  550mm x 350mm x 105mm
- Workable area: 20 7/16" x12 1/2" x 2 1/2" or 520mm x 317mm x 64mm
- Lift speed: 10mm/s
- Lift weight: 3.5kg (8.0lb) at 3200 (1/16)
- Motor: 42HS02 1.8A 2 phase 4 wires
- Frame: aluminum
- Bed: metal and plated in black

 

Suggested motor  driver: Mini 2 Phase 2A 1-axis Stepping Motor Driver

 


Reviews

Average Rating:
(based on 1 review)

Showing 1 Review:

RatingReviewerReview
by Tom Woodrow
on 4/3/2018
LSR-PWRTB530 Power table/ bed kit for P530 500x300
Kit went together fairly easy especially since the K40 power bed kit instructions/pictures were the only instructions available. Seeme even those were done by a third party. Kit was well packaged. Suggestions: 1) Shorten the drive belt, and use a better tension device. The supplied device has to dive at least 5" into the frame to tighten the belt. 2) The Belt tension is on the front, not on the side as shown in the picture. 3) Provide the ratio of stepper motor steps per distance of travel.
Review and Rate this Item

Other Items In This Category

Top Sellers