(17)
Average rating 9.41176470588235 out of 10 ( based on 17 reviews )

Great.

Review by John Hardy on 6/6/2019

Great quality. I assembled mine with no issues at all. No instructions needed. I have not fully installed it yet, but this is a no-brainer: get one. There was one Philips screw where the Philips slots were not properly formed, but there were a couple of spare screws in the kit, so no problem. Light years ahead of the stock bed. Of course, a sand bag would be light years ahead of the stock bed, but this Z-table is the ideal solution.

Not Perfect, But Close

Review by Juan on 6/10/2019

Very well packed, but even so one lead screw was bent slightly, causing occasional binding. There are no instructions so not for the mechanically challenged (just like the K40). If you have a stock controller like the nano, you will need a separate stepper driver and controller to make it move. I used an arduino with a drv8825, some button modules from OSEPP, and a 12 3A PSU. There are no places to mount limit switches, so you have to make your own mount and figure out where to install it. I think it's well designed, although you do loose 20mm both in x and y from the wide border.

Write a Review