5 Axis Break-Out Board for CNC Stepping motor. Support Mach3 and Kcam

(4)
Retail Price: $39.50
Price: $19.50
  • SKUECNC-5XBO-V5
88 units available
- +
5 axis break-out board for CNC stepping motor. Supports Mach3 and KCam.


Features:
  • * Supports 5x stepping motor simultanously
  • * Built-in Relay control for spindle
  • * Supports limit sensor input

Specification:
  • * In/Out Interface port: Parallel
  • * On board Spindle Relay control
  • * Channel: 5 -> X, Y, Z,A,B
  • * Power: DC 5V
  • * Support: March2, KCam

(4)
Average rating 8.5 out of 10 ( based on 4 reviews )

No manual

Review by Paulo Waisberg on 11/13/2010

I just received the break-out board, it looks good but there's no diagram showing how to make the connections and the labeling on the board itself is not clear at all. I would like you to please post a wiring diagram or send it by email. Thanks!

No manuel

Review by Karl on 3/30/2011

I just received the break-out board, it looks good but there's no diagram showing how to make the connections and the labeling on the board itself is not clear at all. I would like you to please post a wiring diagram or send it by email. Thanks! [email protected]

Manual

Review by Marco on 4/1/2011

Manual is available at the Support site http://www.lightobject.info

5 Axis CNC brake out board.

Review by William on 10/17/2011

I have just received my board and no manual. I read that a manual is at the support site, Where is the support site that have this manual.

Write a Review